When last we spoke, I was in a somewhat troublesome state. I was at the end of the second strip of the Wedding Blanket, and had realized that the beginning of the strip:
Didn’t exactly look much like the end of the strip:
Namely, the problem was that I needed a few more rows to get the same effect on both ends. Doing more rows, however, would cause this strip to be longer than the middle and also look funky in the tree panel, so that solution was right out. Ignoring it was also a possibility (what I like to call The Amish Solution), but one that even non-knitters would be likely to recognize.
After sleeping on the problem, I came up with a solution – Knitting Plastic Surgery.
In regular Knitting Surgery, you do something very precise like unravel a few stitches for a few rows to get to a mistake and then knit them back in the right pattern. In Knitting Plastic Surgery (a term that, according to Bing, has only been used once – by SJ on a post by limedragon), I’m going to claim that one is engaging in Knitting Surgery in order to lessen – but not fix – a mistake. (Note: this is not how SJ is using it in her comment – what she’s referring to is what I call regular Knitting Surgery.)
Armed with my new plan, I immediately took the four worst offending stitches and unraveled them to two rows past the cable cross.
I then picked up the remaining stitches with the left needle.
Instead of following the pattern (which would here have me knit two rows plain before crossing the cables), I immediately crossed them, thus allowing me to have three rows of plain knitting after the cross instead of one. That makes the edge noticeably better, without being a hugely obvious mistake in the shortened distance between crossings.
And with that, I’m calling this panel done. In fact, I’ve been working so hard (while I haven’t been blogging) that this panel is cast off and I’m already almost half done with the third – and final – panel. It’s amazing what a deadline can do for a project…
